Cooling tower water conditioning - Water born decease purification treatment
Click the Aqua Correct Logo. Water conditioning and lime scale treatment. Water surface tension reduction. Hard water descaler
Physical Water Conditioning Technique
 Nielsen Technical Trading
P.O.Box 10, DK-4621 Gadstrup, Denmark
Phone: (+45) 46 19 09 90      Fax: (+45) 46 19 09 70
aqua-correct@aqua-correct.dk
Click the Aqua HP-Systems Logo. Hydro physical water purification. Exterminate bacteria's, algae, fungus and other organic micro organism
HOME WHY US ??? IMPORTANT TECH INFO QUICK INDEX PRODUCTS NEWS CONTACT

Water Purifier, Click Logo: Link to: Extermination of bacteria and biological contamination

Physical water conditioning in cooling towers is preferred as an alternative to chemical treatment for environmental, corrosion, and economical reasons.

The chemical procedure requires a pH- neutral balance and the physical a water conductivity balance.  The chemical dosage limit and physical energy limit are proportional, but not the impact on the environment and the costs involved.

By evaporation of water the concentration of mineral salts increases. Draining to remove these impurities is therefore necessary and an important part of the treatment (valid for chemical as well as physical conditioning). The limit of accepted concentration is defined in international standards.

WHY CHOOSE AQUA-CORRECT ®  PHYSICAL WATER TREATMENT

Proven track record with over 3500 units in use on cooling towers in Europe

Solid deposits and impurities removed within 3 to 6 months
Improved efficiency seen within two weeks
No expensive chemical additives
No environmental pollution
Reduced water surface tension by at least 10%
Increased dispersion of the water drops and the exchange of evaporated heat
Pay back time averages less than 8 months
Full satisfaction guarantee
LINK: Saving results US-Dollars 50000,- / year. Cooling Tower installation reference

Cooling tower water container with physical water conditioning and automatic draining:
The AQUA CORRECT conditioner is installed on the make up water supply (upper right corner)
The automatic conductivity limit control processor is mounted on the wall.
The conductivity measuring sensor is installed in the lower part of the water tank.
Draining is performed at the very bottom of the tank by a pipeline with constant fall to earth and opened and closed by a magnet valve, when the water conductivity reaches the set limit values.

NIELSEN TECHNICAL TRADING ApS - P.O.Box 10
DK-4621 Gadstrup - Denmark
aqua-correct@aqua-correct.dk